Attaching The Slides - HP D7171A - NetServer - LPr Installation Manual

Chapter 13

Attaching the Slides

The following steps describe how to attach the slides to the columns.
14. Remove the removable mounting flange. A large, flat-blade screwdriver
inserted between the flange and the slide from the end of the slide may
help in removal. This mounting flange is not required when installing a
slide in an HP systems rack.
15. Remove hex nuts and lock washers securing the removable mounting
flange to the slide. Save the hex nuts and lock washers.
16. Hold the slide so the slide members extend out the front of the rack (see
Figure 13-5).
1. Note the removable
mounting flange has
been removed.
3. Use hex
nut and
lock washer
to fasten
slide to
inside face.
150
2. Insert two screws through
the front column and start the
screws in a bar nut.
Figure 13-5. Attaching the Slides
Alternative Rack Mounting
4. Insert the
slide in place
behind the
column face
but in front
of the bar
nut.