Connecting Scsi Sub-Systems; Integrated Hp Netraid - HP D7171A - NetServer - LPr Installation Manual

Chapter 4

Connecting SCSI Sub-Systems

The second LVD SCSI connector, bus B, can be used to connect to peripheral
sub-systems such as the HP RS/12 or DLT tape libraries.
NOTE
SCSI channel B has SE and LVD connectors.
CAUTION
Do not mix high voltage differential (HVD) driver and
receiver devices with the SE, LVD (Ultra2), or multimode
devices on the same SCSI bus.

Integrated HP NetRAID

The HP NetServer contains an integrated HP NetRAID controller, which puts the
power of the HP NetRAID series of DACs (disk array controllers) in the
NetServer.
Refer to the Integrated HP NetRAID Controller Configuration Guide for complete
information. You can also find the guide on the following HP web site:
http://www.hp.com/go/netserver
NOTE The HP NetServer ships with NetRAID as the default. If you
plan to configure mass storage using LVD SCSI, you must
change this option in the Setup utility.
52
Installing Mass Storage Devices