HP D7171A - NetServer - LPr Installation Manual page 13

Chapter 1
Store the empty boxes and packing material in a safe place. This is
especially important if you plan to ship the HP NetServer elsewhere for
final installation.
CAUTION
The HP NetServer LH 3000r and LH 3000 each weigh up to
165 pounds (75 kgs). More than one person is required to lift a
server. Do not attempt to lift the HP NetServer by yourself.
Failure to observe this warning could result in serious injury
or damage to the HP NetServer.
2. Familiarize yourself with the controls, ports, and indicators.
Refer to Chapter 2, "Controls, Ports, and Indicators."
NOTE
Lock the casters to steady the system while you work on it.
3. If you have optional items to add to the HP NetServer (memory, accessory
boards, mass storage, or processors), remove covers and the bezel. If not,
skip to step 8.
Refer to Chapter 3, "Opening and Closing the HP NetServer."
4. To install a processor and DIMMs, HP recommends that you remove the
system board assembly from the server chassis and install them at this
time.
Refer to Chapter 5, "Installing Additional Memory," and Chapter 7,
"Installing Additional Processors."
5. Install PCI hot-plug and non-hot-plug accessory boards in the
HP NetServer.
Refer to Chapter 6, "Installing Additional PCI Boards."
6. Install internal non-hot-swap mass storage devices such as hard drives and
tape back-up devices into the front of the HP NetServer.
7. Install the system board assembly into the HP NetServer if you removed it.
8. Install non-hot swap disk drives, tape drives, and other mass storage
devices into the front of the HP NetServer.
Refer to Chapter 4, "Installing Mass Storage Devices."
9. Reconnect all internal cables.
Setting Up the HP NetServer LH 3000r and LH 3000
5