8 Installing the HP NetServer in the HP
Rack System/E or Rack System/U
Introduction
This chapter describes how to mount the HP NetServer in an HP System/E or /U
rack. If you have an older HP System rack, see Chapter 13, "Alternative Rack
Mounting," for instructions. (If you are mounting the HP NetServer in a non-HP
rack, refer to the separate rack-mounting guide for third-party racks. It is packed
in the accessories tray in the HP NetServer's shipping box.)
HP NetServer and Rack Components
The HP NetServer LH 3000r requires eight EIA units of space.
Slide
Leveler
Foot
Inside Face
Bar
Nuts
Rack
Anti-Tip
Template
Foot
Figure 8-1. Installation Hardware
Outside
Face
Handles
Bezel
NetServer
Latch
Slide
Bezel
Member
Hinge
Bezel
85