Securing The Hp Netserver To The Rack - HP D7171A - NetServer - LPr Installation Manual

Chapter 8 Installing the HP NetServer in the HP Rack System/E or Rack System/U
Figure 8-12. Removing Mounting Handles

Securing the HP NetServer to the Rack

Complete the following steps to secure the HP NetServer to the rack and install
the front bezel.
1. Attach the bezel hinge to the HP NetServer with three screws through the
right edge of the bezel hinge and into the left front of the HP NetServer
(see Figure 8-13).
2. Attach the bezel latch to the right side of the HP NetServer with two
screws.
3. Depress the slide lockout latches, and push the HP NetServer completely
into the rack (see Figure 8-13).
98