Installing Additional Memory; Introduction; Memory Guidelines - HP D7171A - NetServer - LPr Installation Manual

5 Installing Additional Memory

Introduction

This chapter describes adding memory to the HP NetServer LH 3000r and
LH 3000. The standard configuration ships with one 128 MB DIMM in slot 0.
DIMM Socket 0
DIMM Socket 1
DIMM Socket 2
DIMM Socket 3
Figure 5-1. DIMM Sockets on System Board Assembly

Memory Guidelines

l
Add DIMMs of these sizes:
128 Mb
256 Mb
512 Mb
1 GB
l
Add memory in any order to the four slots.
l
You can mix DIMM sizes. For example, you may place a 1 GB DIMM
next to a 128 Mb DIMM.
l
Maximum configuration is 4 GB.
l
Do not rock the DIMM into place, but apply firm and even pressure until it
is seated in the socket.
l
Use only HP-supported DIMMs.
NOTE
If non-HP DIMMs are used, the NetServer will report this
during boot.
53