Power States; Attaching The Hook-And-Loop Strap To The Bulk Power Supply And Power Cord - HP Integrity rx3600 Installation Manual

Power States

The server has three power states:
standby power
full power
off
To get to standby power state plug the power cord into the appropriate receptacle on the rear of
the chassis. The front panel Power button is not turned on.
Full power occurs when the power cord is plugged into the appropriate receptacle and either the
power is activated through the iLO 2 MP PC command, or the Power button is activated.
In the off state, the power cords are not plugged in.
Table 9 lists the server power states.
Table 9 Power States
Power States
Standby power
Full power
Off
NOTE: If the power restore feature is set to Always On through the iLO 2 MP PR command, the
server can automatically power on to the full power state.
Figure 15 shows the rear panel power receptacles and power supply LEDs.
Figure 15 Rear Panel Power Receptacles and Power Supply LEDs

Attaching the Hook-and-Loop Strap to the Bulk Power Supply and Power Cord

CAUTION:
cord, the power cord might pop off the back.
To attach the hook-and-loop strap to the bulk power supplies and power cord, follow these steps:
1. Attach the hook-and-loop strap to the handle on the bulk power supply.
34 Installing the System
Power Cable Power Activated through the iLO 2 MP PC
Plugged Into
Command; or Front Panel Power Button
Receptacle Activated
Yes No
Yes Yes
No No
If you do not fasten the hook-and-loop strap to the bulk power supply and the power
ac Voltage dc Voltage
Applied Applied
Yes No
Yes Yes
No No