HP D7171A - NetServer - LPr Installation Manual page 87

Chapter 7
17. Processor speed switches are set for the processor speed that ships with
your system.
NOTE Only the first four switches set the processor speed.
After installing processors, verify that the configuration switches are set correctly.
If the switches are not correct, set them accordingly.
To set the configuration switches:
18. Locate the configuration switches on the system board.
19. Look up the appropriate switch settings for the processors installed in the
HP NetServer.
Figure 7-9. Configuration Switch and Settings
20. Use a small, flat-blade screwdriver or similar tool to change the switches.
Installing Additional Processors
ON
Configuration
1 2 3 4 5 6 7 8
Switch
79