Attaching The Slides - HP LC2000r - NetServer - 128 MB RAM Installation Manual

Chapter 8 Installing the HP NetServer in an HP Rack System/E or Rack System/U
The slots in the mounting flange allow you to insert the flange in place behind the
outside face but in front of the bar nut.
The mounting flanges are then positioned behind the column face, but in front of
the bar nuts.

Attaching the Slides

The slides have mounting flanges at each end (see Figure 8-7). The mounting
flange is inserted between the column and the bar nut.
The slots in the mounting flange allow you to insert the flange in place behind the
outside face but in front of the bar nut.
The mounting flanges are then positioned behind the column face, but in front of
the bar nuts.
86
Place bar nut
behind outside
face of column.
Start two screws
in bar nut but do
not tighten.
Figure 8-6. Attach Bar Nuts