× Bookmark added
Page of 182
Download Table of Contents

HP D7171A - NetServer - LPr Installation Manual Page 121

Hp netserver lh 3000 installation guide.
Hide thumbs

Advertisement

Chapter 10
Show System Information:
Use this screen to display information about standard and accessory boards
and devices in the system, as well as the used and available system
resources.
Select View Hardware Inventory on the Show System Information
screen to display information about standard and accessory boards and
devices in the system.
Select View Resources on the Show System Information screen to
display used and available system resources such as memory ranges,
I/O port ranges, DMA channels, and interrupt (IRQ) levels.
Configure Disk Array:
This configures your HP disk array, but requires you to fill out the Disk
Array Configuration Worksheet, before proceeding. Click Help for more
details.
NOTE
When you configure an array, the default cache mode is
write-through. For write-back mode, install the battery back-up
accessory and a universal power supply.
Install Utility Partition:
This step creates a 32 MB DOS-based utility partition on the NetServer
hard disk where HP Navigator will copy DiagTools, the BIOS Update
utility, the Event Log Report utility, the Disk Array utility, the NIC
Configuration utility, the Integrated Remote Assistant utilities,
troubleshooting utilities, and other utilities. However, this is not available
for SCO UNIX.
Select Execute on the Install Utility Partition screen.
Execute Card Utilities:
Use this function, when Configuration Assistant detects installed boards,
which have additional configuration utilities on the HP NetServer
Navigator CD-ROM. By selecting Execute on the Execute Board Utilities
screen, you can execute these utilities to complete the configuration of the
boards.
Configuring the HP NetServer
113

Advertisement

   Related Manuals for HP D7171A - NetServer - LPr

Comments to this Manuals

Symbols: 0
Latest comments: