HP D7171A - NetServer - LPr Installation Manual page 155

Chapter 13
Marking Rear Columns
5. Mark the slide mounting holes on the inside faces of the rear columns.
6. Mark the baseline (bottom) of the NetServer at an EIA unit mark on the
column.
7. Hold the bottom of the rack template at the baseline. Mark the top of
NetServer (8 EIA units counted up from the baseline).
8. Mark the slide mounting hole (hole 21 counted up from the baseline).
9. Mark the second rear column by repeating steps 5 through 8.
Use the template to
measure, or count up
21 from baseline on inside
face for rear slide mounts.
Template
p/n
5064-
5869
Base line
The inside face
is the one inside
the rack (at 90
degrees to you
when you
open the
rack door).
Figure 13-2. Marking the Rack Columns
Alternative Rack Mounting
The slides
fasten
behind
the outside
face of the
front of
the rack,
at the
22nd and
20th holes
above the
unit below.
147