HP D7171A - NetServer - LPr Installation Manual page 65

Chapter 5
7. Slide the system board assembly from the chassis and place it metal plate
side down on an anti-static pad.
8. Install the DIMMs:
a. Spread the latches outward on each socket to receive a DIMM.
b. Remove a DIMM from its anti-static bag, handling the module by its
edges.
c. Align the notches on the DIMM with the slot keys on the socket.
CAUTION
Do not rock the DIMM into place, but apply firm and even
pressure. If a gap exists between the retaining latches and the
DIMM, remove and replace the module until no gap exists.
Figure 5-5. Align DIMM Notches with slot keys
d. Press the DIMM into the socket until the latches close.
NOTE
If the latches do not close, repeat until they do.
Installing Additional Memory
Align DIMM notches
with slot keys.
57