Chapter 6
Boot Priority
Some boards have preferred slot locations. If not, consider the boot order when
choosing the accessory board slot in which to install the accessory board.
This is the default boot priority for the LH 3000r and LH 3000:
1. IDE CD-ROM drive with a bootable CD-ROM
2. Flexible disk drive with a bootable flexible disk
3. HP NetRAID controller or integrated Embedded SCSI controller
4. PCI boards in slots in the following order: 8, 7, 6, 5, 4, 3, 2, and 1
You can change this boot order using the Setup utility. Press [F2] during the boot
process as described in Chapter 10, "Configuring the HP NetServer."
Tested PCI Boards and Drivers
For a list of tested PCI boards, check "Configuration Assistant" on the HP
NetServer Navigator CD-ROM, or look for the Hardware Tested Products link for
the LH 3000r and LH 3000 under NetServer Service and Support for the NOS
used at:
http://www.hp.com/netserver/servsup/compatibility
For current PCI Hot-Plug information regarding NOS support and the availability
of PCI Hot-Plug compliant drivers, search for pcihotplug on HP's website at:
http://www.hp.com/netserver/products/LH 3000
Installing Accessory Boards
NOTE
To hot add or hot replace hot-plug accessory boards, refer to
"Hot Adding or Replacing Hot-Plug PCI Boards" later in this
chapter.
Use this procedure to install accessory boards during the initial installation
process and the following:
PCI Hot-Plug boards when the HP NetServer is not powered up
All PCI boards in slots 1 through 4 (non-hot plug)
Skip any steps that do not apply to your installation.
62
Installing Additional PCI Boards
Need help?
Do you have a question about the D7171A - NetServer - LPr and is the answer not in the manual?