Fw Info (Firmware Information) Menu; Hw System Info Menu - HP D7171A - NetServer - LPr Installation Manual

Chapter 2

FW Info (Firmware Information) Menu

The FW Info menu displays the versions of all firmware components in the
system.
1. Select FW Info from the Main Menu.
A display similar to the one shown below appears on the NetServer's front
panel display.
**FW Info***
2. Use the arrow buttons to scroll down through the rest of the information.
NOTE
If the system cannot detect one of the components in this menu
-- for example, the TopTools Remote Control card (RCC) --
the word "absent" appears next to the component in place of a
version number.
3. Press Escape to return to the Main Menu.

HW System Info Menu

The System Info menu displays the NetServer's configuration information.
Information includes the number, speed, and type of CPUs, cache information,
and the amount of RAM on each memory board.
1. Select System Info from the Main Menu.
A display similar to this appears on the NetServer's status screen.
**System Info***
No. Of CPUs=x
2. Use the down-arrow button to scroll through the rest of the information.
A full screen of the display would appear as shown below, but the actual
display is still limited by two viewing lines at time.
**HW Sys Info***
No. Of CPUs=x
CPU speed 500MHz
CPU type PIII
L2 Cache xxxx KB
LFT CPU1 stepping xx
LFT CPU2 stepping xx
Mem slot1 xxxxMB
Mem slot2 xxxxMB
Mem slot3 xxxxMB
Mem slot4 xxxxMB
3. Press Escape to return to the Main Menu.
Controls, Ports, and Indicators
17