Installing Bar Nuts - HP D7171A - NetServer - LPr Installation Manual

Chapter 13

Installing Bar Nuts

The "bar nut" is a two-hole metal bar used to secure the mounting flanges of the
slide to the front columns.
12. Hold the bar nut behind the outside face of the front column, at the slide
screw holes marked earlier. Start (but do not tighten) two screws through
the face of the into the bar nut.
13. Install the bar nuts on both front columns.
Place bar nut
behind outside
face of column.
Start two screws
in bar nut but do
not tighten.
Figure 13-4. Installing Bar Nuts
Alternative Rack Mounting
149