6 Installing Additional PCI Boards
Introduction
This chapter describes how to install accessory boards, during initial installations,
into the I/O board. The I/O board is under Cover 1 on the top of the
LH 3000r and under the left cover of the LH 3000.
If you want to do a "hot" add or "hot" replacement (with the HP NetServer
powered up), go to Hot Adding or Replacing Hot-Plug PCI Boards at the end of
this chapter.
Remote
Management
Slots 1- 4
Non-hot-plug
Slots 1- 6
+5V
33 MHz/64 Bit
Slots 5- 8
Hot-plug
Slots 7 and 8
Universal
33 MHz/64 Bit
Power LEDs
Slots 1 through 6 support +5 volt PCI boards. Slots 7 and 8 support +3.3 volt, +5.0
volt or Universal PCI boards. All eight slots accept 64-bit PCI boards. Slots 5
through 8 are hot-plug enabled.
Integrated NetRAID Memory
Attention LEDs
Figure 6-1. I/O Board
SE SCSI
SCSI A
SCSI B
59