Removing A Hot-Plug Board - HP D7171A - NetServer - LPr Installation Manual

Chapter 6

Removing a Hot-Plug Board

If you want to remove or replace a hot-plug PCI board, go to "Hot Adding or
Replacing Hot-Plug PCI Boards" in the following section. To remove a hot-plug
board from the HP NetServer which is not running:
1. Make sure power is off and follow the instructions for accessing the I/O
board.
2. Pull the brown plastic slot separator out until you feel resistance (about
three-eighths of an inch, or 10mm).
This releases the hot-plug board from the connector.
3. Remove the hot-plug board.
4. Either replace the hot-plug board or reinstall the slot cover.
NOTE
To perform a hot add, or a hot-plug board installation when the
HP NetServer is powered up, refer to "Information Assistant"
on the HP NetServer Online Documentation CD-ROM.
68
Figure 6-5. Removing a Hot-Plug Board
Installing Additional PCI Boards