Download Print this page

HP D7171A - NetServer - LPr Installation Manual: Tools Required; Installing Memory In The Lh 3000r And Lh 3000

Hp netserver lh 3000 installation guide.
Hide thumbs

Advertisement

Chapter 5

Tools Required

l
An anti-static service kit (3M 8501/8502/8503 or equivalent). This kit
includes a static-dissipating work surface, a chassis clip lead, and a wrist
strap.

Installing Memory in the LH 3000r and LH 3000

CAUTION
Extend the anti-tip foot prior to any work on a rack-mount
server.
The installation procedure is the same for the rack-mount and the pedestal HP
NetServers once you gain access to the system board assembly.
1. Log off all users and gracefully shut down the network operating system
according to directions in your NOS documentation.
2. Power down the HP NetServer according to the instructions in Chapter 2,
"Controls, Ports, and Indicators."
3. Disconnect the power cord and cables and, if necessary, label each one to
support re-assembly.
CAUTION
The power supplies will continue to provide standby current to
the NetServer until the power cable is disconnected.
4. For rack-mount and pedestal models, follow the instructions in Chapter 3,
"Opening and Closing the HP NetServer," to gain access to the server.
NOTE
In the LH 3000r this assembly is under the right cover; in the
LH 3000 it is under the top cover.
While you can perform the installation in the rack or in the pedestal, HP
recommends that you remove the system board assembly to install components.
54
Installing Additional Memory

Advertisement

Troubleshooting

   Related Manuals for HP D7171A - NetServer - LPr

Comments to this Manuals

Symbols: 0
Latest comments: