Installing The Hp Netserver - HP D7171A - NetServer - LPr Installation Manual

Chapter 8 Installing the HP NetServer in the HP Rack System/E or Rack System/U

Installing the HP NetServer

The following steps require lifting the HP NetServer with the mounting handles,
placing it in front of the slide members, and sliding the slide members underneath
the handles to secure it to the slides installed in the rack.
WARNING
Extend the anti-tip foot from the front of the rack and lower
all leveler feet to stabilize the rack before mounting rack
components. Failure to use the anti-tip foot and leveler feet
could result in serious injury.
1. Lower the four rack leveler feet to the floor, lifting the rack off the
rack wheels (see Figure 8-9).
2. Fully extend the anti-tip foot from the front of the rack.
Lower
leveler feet.
Extend
anti-tip foot.
Figure 8-9. Preparing the Rack for HP NetServer Installation
Lockout
Latch
Lockout
Latches
Extend slide
members until
they lock.
95