Attaching The Slides To The Rack - HP D5970A - NetServer - LCII Installation Manual

Chapter 8
5. Attach rack nuts to the outside face of the other front rack column.
See Steps 2 through 4.
6. Turn the template over and use it to mount rack nuts on the left-rear and
right-rear rack columns.
The template provides you with the nut placement locations. If you don't
have the template, Figure 8-4 shows rack nut placement for the two rear
rack columns.
Left
Rear of
Rack
Attach nuts to this face
of the rear columns
Figure 8-4. Rack Nut Locations on the Rack's Rear Columns

Attaching the Slides to the Rack

1. Pull the anti-tip foot forward out of the bottom of the rack.
See Figure 8-5 for the anti-tip foot location.
2. Hold a slide in position inside the two left-hand rack columns:
a. The mounting flange on each end must wrap around the outside face of
both the front and rear columns. See Figure 8-5.
b. The two holes in the mounting flange should line up with the two
lowest rack nuts you installed on each column.
c. The extending portion of the slide (slide member) should point forward
out of the rack.
94
Right
Bottom of
Server
Rack Mounting the HP NetServer
# "#" represents
the EIA unit
numbers on the
#
columns
rack
#
#
Sixth Hole
From Bottom
#
Fourth Hole
From Bottom
#