HP D7171A - NetServer - LPr Installation Manual page 21

Chapter 2
Resets the NetServer. This switch may be disabled by Secure
RESET RESET
mode.
Or
Secure Mode Locks system keyboard, monitor display, and control panel to
prevent unauthorized use. Go to the Setup utility security menu
Indicator
to configure this feature. Secure Mode LED illuminates when
Secure Mode is enabled.
Status screen Reports system status. For details, see the following section:
"Viewing System Information."
Server Status LEDs
Red
Yellow
Green
Red Yellow Green
LED LED LED
Off Off Off
Flashing Off Off
Off Flashing Off
Off Off On
Three LEDs -- one red, one yellow, one green -- are on
the right side of the front panel console. They give you
a quick idea of the HP NetServer's general health. The
signals provided reflect the most critical pending event
in the system.
Indicates NetServer Status:
Main power is off and the NetServer may or may not be
on standby power.
Immediate attention required due to a failed component
in the NetServer. The NetServer may not be fully
operational due to this condition, such as POST errors.
Attention required due to a pre-failure condition. This
condition may be caused by a component failure (for
example, a redundant fan or power supply) that could
lead to a critical component failure, such as a processor
module exceeding its operating temperature. If the
failed component is redundant, the NetServer may still
be operating normally.
The NetServer is operating normally.
Controls, Ports, and Indicators
13