HP D7171A - NetServer - LPr Installation Manual page 40

Chapter 3
Remove two screws
Securing the Netserver
to the rack.
Figure 3-4. Front of LH 3000r Screw and Cover Locations
5. The z-bracket is used only during shipment to secure the NetServer to the
rack. To remove the z-bracket, remove the two screws that connect the
z-bracket to the column at the rear of the NetServer. Save the z-bracket for
future use.
32
Opening and Closing the HP NetServer
Cover 1
Do not remove the
three screws securing
the hinge to the Netserver.
Figure 3-5. Remove Z-bracket
Remove the two
screws securing
the NetServer to
the rack.
Do not remove the
two screws securing
the bracket to the
NetServer.
Cover 2
Cover 3
Z-Bracket Z-Bracket
Remove the
two screws
holding the
NetServer to
the bracket.