HP D7171A - NetServer - LPr Installation Manual page 11

Chapter 1
3. If you have optional items to add to the HP NetServer (memory, accessory
boards, mass storage, or processors), remove covers and the bezel. If not,
skip to step 8.
Refer to Chapter 3, "Opening and Closing the HP NetServer."
4. If you have items such as a processor and DIMMs to install, HP
recommends that you remove the system board assembly from the server
chassis and install them at this time.
Refer to Chapter 5, "Installing Additional Memory," and Chapter 7,
"Installing Additional Processors."
5. Install PCI hot-plug and non-hot-plug accessory boards.
Refer to Chapter 6, "Installing Additional PCI Boards."
6. Install internal non-hot-swap mass storage devices such as hard drives and
tape back-up devices into the front of the HP NetServer.
Refer to Chapter 4, "Installing Mass Storage Devices."
7. Reconnect internal cables as needed.
8. Install the server in the rack.
NOTE
If you removed the system board assembly, wait to replace it in
the chassis until the server is in the rack. This reduces the
weight of the server making it easier to mount.
Refer to Chapter 8, "Mounting the HP NetServer in the HP Rack System/E
or Rack System/U" or Chapter 13, "Alternative Rack Mounting."
9. If necessary, re-install the system board assembly in the rack-mounted
chassis.
10. Replace covers, but not the bezel.
Refer to Chapter 3, "Opening and Closing the HP NetServer."
11. Install hot-swap mass storage devices into the front of the HP NetServer.
Refer to Chapter 4, "Installing Mass Storage Devices."
12. Replace the bezel.
Refer to Chapter 3, "Opening and Closing the HP NetServer."
13. Install the power supplies to the rear of the HP NetServer.
Setting Up the HP NetServer LH 3000r and LH 3000
3