Tools Required; Rack-Mounting Guidelines And Precautions - HP D7171A - NetServer - LPr Installation Manual

Chapter 8 Installing the HP NetServer in the HP Rack System/E or Rack System/U
NOTE The pedestal HP NetServer LH 3000 cannot be rack-installed
without a conversion kit. Contact your HP reseller for
information about the HP NetServer LH 3000 to LH 3000r
Conversion Kit.

Tools Required

The following tools are required to mount the HP NetServer in the rack:
Torx 15 driver
Torx 25 driver
HP NetServer LH 3000r Rack Template
l
Tape or a marker pen to mark mounting locations

Rack-mounting Guidelines and Precautions

Observe the following guidelines and safety precautions during the rack-mount
installation.
l
Extend the rack's anti-tip foot (see Figure 8-2) prior to any work on the
rack to prevent rack tip-over, equipment damage, and injury.
WARNING
Lower the leveler feet at the four corners of the rack to
improve stability and prevent the rack from rolling away as
devices are inserted into their rack mounts. Failure to use the
anti-tip foot and leveler feet could result in serious injury.
l
Uneven mechanical loading within the rack can cause hazardous
conditions. Plan the placement of equipment in the rack to ensure balanced
loading.
CAUTION
If other rack components are to be mounted in the rack below
the HP NetServer, install those components before starting to
mount the NetServer.
Install components from the bottom up.
Place the heaviest components on the bottom of the rack.
86