10. Replace covers and the bezel.
Refer to Chapter 3, "Opening and Closing the HP NetServer."
11. Connect the monitor, keyboard, mouse and power supplies.
Refer to Chapter 9, "Connecting Monitor, Keyboard, Mouse, and Power
12. Connect external cables.
13. Power up the HP NetServer.
Refer to Chapter 2, "Controls, Ports, and Indicators."
Go to the next section, "Configuring the HP NetServer."
Configuring the HP NetServer
1. Load the HP Navigator CD-ROM. Place the HP NetServer Navigator
CD-ROM in the drive and close the drive.
To fully configure the HP NetServer, all the rack components
must be cabled and online (though not necessarily installed in
Refer to Chapter 10, "Configuring the HP NetServer."
Setting Up the HP NetServer LH 3000r and LH 3000
Figure 1-4. Navigator CD-ROM