3 Opening and Closing the HP
NetServer
Introduction
Use this chapter to see how to open and close the HP NetServer to add
components. Components such as DIMMs and processors are on the system board
shown outlined below.
WARNING
LH 3000r
Figure 3-1. System Board Assembly Location
Before removing covers, disconnect the power cords and
unplug telephone cables. If possible, shut down the operating
system. Disconnect the power cords to avoid exposure to high
energy levels that may cause burns when parts are
short-circuited by metal objects, such as tools or jewelry.
Disconnect telephone cables to avoid exposure to shock
hazard from telephone ringing voltages.
Wear a grounded wrist strap and use a static-dissipating work
surface when handling NetServer components.
Note that the power switch does not turn off the standby
power. Disconnect the power cords to turn off standby power.
LH 3000
29