Installing The Rack Nuts - HP D7171A - NetServer - LPr Installation Manual

Chapter 3
7th
3rd
7th
3rd
(At Rear
Of Column)
Figure 3-1. Marking Holes for Installation
Now mark two holes on each of the front columns to use for the rack nuts where
the server-attachment screws secure to the columns.
To mark the server-attachment holes on the front columns (refer to Figure 3-1),
count up from the top of the unit below, marking the 9th, and 17th holes.

Installing the Rack Nuts

Once you have marked the holes, install supplied rack nuts in each hole
(previously marked) on all columns (see Figure 3-2). You should install 12 rack
nuts total in the holes marked.
8
6th
4th
17th
9th
6th
4th
Installation
17th
9th
Template (optional)
Unit Below
Intended Installation
Location