Connecting Ethernet Ports; Uplink Ports - Comtrol ROCKETLINX ACS7106 Quick Installation Manual

CONNECTING ETHERNET PORTS

Connect one end of an Ethernet cable into the Ethernet
port of the ACS7106 and the other end to the attached
networking device:
• Ports 1-4 are Fast Ethernet (10/100BASE-TX) PoE that
support IEEE 802.3af/802.3at (PoE+)
• Ports 5-6 are Gigabit (10/100/100BASE-TX)
Half and full-duplex connections are supported with
auto-negotiated link speed and duplex mode. Auto
MDI/MDIX enables direct connection of another hub or
switch without the need for crossover cabling. Link/Act
LEDs are lit to indicate traffic and link status. See the
LEDs subsection on back for more information.
NOTE: The ACS7106 is to be connected to PoE networks
without routing to outside the plant.
Always make sure that the cables between the
switches and attached devices (for example, switch,
hub or workstation) are less than 100 meters (328 feet).
Use the following cabling guidelines:
• IEEE 802.3af: 4-pair UTP/STP Category 5 or higher
cable, EIA/TIA-568 100-ohm
• IEEE 802.3at: 4-pair UTP/STP Category 5e/6 or higher
cable, EIA/TIA-568 100-ohm

• Uplink ports

• 10BASE-T: 2-pair UTP/STP Category 3, 4, 5, or
higher cable, EIA/TIA-568 100 ohm
• 100BASE-TX: 2-pair UTP/STP Category 5 or higher
cable, EIA/TIA-568 100 ohm
• 1000BASE-TX: 4-pair UTP/STP Category 5 or
higher cable, EIA/TIA-568 100 ohm
Pin
1
2
3
4
5
6
7
8
10/100BASE-TX PoE
(Alternative B)
RX +
RX -
TX +
Vport+
Vport+
TX -
Vport-
Vport-
- 7 -
1000BASE-TX
BI_DA+
BI_DA+
BI_DB+
BI_DC+
BI_DC-
BI_DB-
BI_DD+
BI_DD-