Table of Contents
Advertisement
Hardware Installation
On the bottom of the ES8105/ES8105F, there is one 5-pin DIP switch for alarm control. If you connect the alarm
Relay Output
on Page 7) and set the DIP switch of the intended Alarm to ON, the relay output forms a short circuit if an alarm
occurs.
Use this table to set the DIP switch for the relay output alarm.
Pin
Status
On
1-5
Off
Mounting the RocketLinx ES8105/ES8105F
You can mount the RocketLinx ES8105/ES8105F on a DIN rail or mounted to the wall. The DIN rail clip is already attached to
the RocketLinx ES8105/ES8105F when packaged.
Note: The RocketLinx ES8105/ES8105F will disperse heat through the metal case during PoE port operation. The
RocketLinx ES8105/ES8105F should be installed and mounted onto a panel which provides good heat dispersion.
You can use this procedure to mount the ES8105/ES8105F on a DIN rail.
1.
Insert the upper end of DIN rail clip into the back of DIN rail track from its
upper side.
2.
Lightly push the bottom of DIN rail clip into the track.
3.
Ensure the DIN rail clip is tightly attached on the track.
4.
To remove the RocketLinx ES8105/ES8105F from the track, reverse the steps
above.
To mount the ES8105/ES8105F on the wall:
1.
Snap the DIN rail plate into the track.
2.
Attach the ES8105/ES8105F to the wall using the mounting screws.
Connecting the Ethernet Ports
You can use the following information to connect standard Ethernet cables between the RocketLinx ES8105/ES8105F 10/
100BASE-TX Ethernet ports and the network nodes. The Fast Ethernet ports support 10BASE-T and 100BASE-TX, full- or
half-duplex modes.
All the Fast Ethernet ports automatically detect the signal from the connected devices to negotiate the link speed and duplex
mode. Auto MDI/MDIX allows you to connect another switch, hub, or workstation without changing straight-through or
crossover cables. Crossover cables cross-connect the transmit lines at each end to the received lines at the opposite end.
Switch
3 TD+
6 TD-
1 RD+
2 RD-
8 - RocketLinx ES8105/ES8105F User Guide: 2000558 Rev. B
Enables the port link down alarm for the corresponding port.
Disables the port link down alarm on the corresponding port.
Router or PC
3 RD+
6 RD-
1 TD+
2 TD-
Straight-Through Cabling
Description
Switch
3 TD+
6 TD-
1 RD+
2 RD-
Crossover Cabling
(Wiring the
Switch
3 TD+
6 TD-
1 RD+
2 RD-
Mounting the RocketLinx ES8105/ES8105F
Advertisement
Table of Contents
