Connecting To The Network - Comtrol ROCKETLINX ES8108 Quick Installation Manual

Connecting to the Network

Connecting the Ethernet Ports
Connect one end of an Ethernet cable into the Ethernet port of the ES8108/ES8108F and the
other end to the attached device. All Ethernet ports support auto MDI/MDIX functionality.
Switch
3 TD+
6 TD-
1 RD+
2 RD-
Straight-Through Cabling Schematic
Always make sure that the cables between the switches and attached devices (for example,
switch, hub, or workstation) are no more than 100 meters (328 feet). The cable must meet
EIA/TIA-568 100-ohm specifications:
• 10BASE-T: 2-pair UTP/STP Category 3, 4, 5, or 5e
• 100BASE-TX: 2-pair UTP/STP Category 5 or 5e
Connecting the Fiber Ports (ES8108F)
Connect the fiber port to another Fiber Ethernet
device using the following diagram.
An improper connection will cause the fiber port
not to work properly. The fiber port is a standard
or square connector (SC).
ATTENTION
This is a Class 1 Laser/LED product.
！
Don't stare into the Laser/LED Beam.
Router or PC Switch
3 RD+
3 TD+
6 RD-
6 TD-
1 TD+
1 RD+
2 TD-
2 RD-
Crossover Cabling Schematic
4
Switch
3 TD+
6 TD-
1 RD+
2 RD-
RX
TX
A
Cable Wiring(SC to SC)
TX A
RX A
RX
TX
B
RX B
TX B