User Permissions; Table 10-1. User Group Rights - Lantronix SecureLinx SLC48 User Manual

User Permissions

The SLC has three default user groups: Administrators, Power Users, and Default Users.
Each has a predefined set of rights: users inherit rights from the user group to which they
belong. These rights are in addition to the current functions that a user can perform at the
CLI:
The table below shows the mapping of groups and user rights.
User Right
Full Administrative Rights
Networking
Services
Date/Time
Local Users
Remote Authentication
SSH Keys
User Menus
Device Ports
PC Card
Reboot/Shutdown
Firmware/Configuration
Diagnostics and Reports
SLC Network
Web Access
You cannot deny a user rights defined for the group, but you can add or remove all other
rights at any time.
Note: You cannot change the rights associated with each group; a future release will
provide that functionality.
By default, the system assigns new users to the Default Users group, but you can change
their group membership at any time. If you change a user's rights while the user is logged
into the web or CLI, the results do not take effect until the next time the user logs in.
To assign user rights:
SecureLinx SLC User Guide
connect direct/listen
set locallog/password/history/cli
show datetime/deviceport/locallog/portstatus/portcounters/
history/cli/user

Table 10-1. User Group Rights

Administrators
10: User Authentication
Power Users Default Users
98