Nfs And Smb/Cifs Commands - Lantronix SecureLinx SLC48 User Manual

SMB/CIFS Shares
Share SMB/CIFS
directory
Network Interfaces
CIFS User
Password
and
Retype Password
Workgroup
4. To save, click Apply.

NFS and SMB/CIFS Commands

The following CLI commands correspond to the web page entries described above.
To mount a remote NFS share:
set nfs mount <one or more parameters>
Parameters:
Note: The remdir and locdir parameters are required, but if you specified them previously, you do
not need to provide them again.
To unmount a remote NFS share:
set nfs unmount <1|2|3>
To view NFS share settings:
show nfs
SecureLinx SLC User Guide
Select the checkbox to enable the SLC to export
an SMB/CIFS share called "public." Disabled by
default.
Select the network ports from which the share can
be seen. The default is for the share to be visible
on both network ports.
Only one user special username (cifsuser) can
access the CIFS share. Enter the CIFS user
password in both password fields. The default
user password is CIFSPASS.
More than one user can access the share with the
cifsuser user name and password at the same
time.
The Windows workgroup to which the SLC
belongs. Every PC exporting a CIFS share must
belong to a workgroup. Can have up to 15
characters.
locdir <Directory>
mount <enable|disable>
remdir <Remote NFS Directory>
rw <enable|disable>
Enables read/write access to remote directory.
7: Services
59