6: Basic Parameters; Requirements - Lantronix SecureLinx SLC48 User Manual

6 : B a s i c P a
6 : B a s i c P a
This chapter explains how to set the following basic configuration settings for the SLC
using the SLC web interface or the CLI:
Note: If you entered some of these settings using a Quick Setup procedure, you
may update them here.

Requirements

If you assign a different IP address from the current one, it must be within a valid range,
unique to your network, and with the same subnet mask as your workstation.
To configure the unit, you need the following information:
IP address: ________. ________ . ________ .________
Eth1
Subnet mask: ________ . ________ . ________ .________
IP address (optional): ________ . ________ . ________ .________
Eth2
Subnet mask (optional): ________ . ________ . ________ .________
Gateway: ________ . ________ . ________ .________
DNS: ________ . ________ . ________ .________
SecureLinx SLC User Guide
r a m e t e r s
r a m e t e r s
Network parameters that determine how the SLC interacts with the attached
network
Firewall and routing
Date and time
40