Nis Commands - Lantronix SecureLinx SLC48 User Manual

Remote
Authentication
SSH Keys
User Menus
Device Ports
PC Card
Reboot &
Shutdown
Firmware &
Configuration
Diagnostics &
Reports
SLC Network
Web Access
5. Click Apply.
Note: You must reboot the unit before your changes will take effect.

NIS Commands

These commands for the command line interface correspond to the web page entries
described above:
To configure the SLC to use NIS to authenticate users who log in via the Web, SSH,
Telnet, or the console port:
set nis <one or more parameters>
Parameters:
To set group and permissions for NIS users:
set nis group <default|power|admin>
SecureLinx SLC User Guide
Right to assign a remote user to a user group and assign a
set of rights to the user.
Right to set SSH keys for authenticating users.
Right to create a custom user menu for the CLI for NIS users.
Right to enter device port settings.
Right to enter modem settings for PC cards.
Right to use the CLI or shut down the SLC and then reboot it.
Right to upgrade the firmware on the unit and save or restore
a configuration (all settings). Selecting this option
automatically selects Reboot & Shutdown.
Right to obtain diagnostic information and reports about the
unit.
Right to view and manage SLCs on the local subnet.
Right to access Web-Manager.
broadcast <enable|disable>
domain <NIS Domain Name>
master <IP Address or Hostname>
slave1 <IP Address or Hostname>
slave2 <IP Address or Hostname>
slave3 <IP Address or Hostname>
slave4 <IP Address or Hostname>
slave5 <IP Address or Hostname>
state <enable|disable>
10: User Authentication
106