Restoring Factory Defaults; Method #2 Quick Setup On The Web Page - Lantronix SecureLinx SLC48 User Manual

Restoring Factory Defaults

To use the LCD display to restore factory default settings:
1. Press the right arrow button to move to the last option, Release.
2. Use the down arrow to move to the Restore Factory Defaults option. A prompt
for the 6-digit Restore Factory Defaults password displays.
3. Press Enter to enter edit mode.
4. Using the left and right arrows to move between digits and the up and down
arrows to change digits, enter the password (the default password is 999999).
Note:
it at the command line interface using the admin keypad password command.
5. Press Enter to exit edit mode. If the password is valid, a Save Settings? Yes/No
prompt displays.
6. To initiate the process for restoring factory defaults, select Yes. When the process
is complete, the SLC reboots.

Method #2 Quick Setup on the Web Page

After the unit has an IP address, you can use the Quick Setup web page to configure the
remaining network settings. This page displays the first time you log into the SLC only.
Otherwise, the SLC Home Page displays. (For information about the web interface, see
Web Interface
To complete the Quick Setup page:
1. Open a web browser (Netscape Navigator 6.x and above or Internet Explorer 5.5.
and above, with JavaScript enabled).
2. In the URL field, type https:// followed by the IP address of your SLC.
3. Log in using sysadmin as the user name and PASS as the password. The first
time you log in to the SLC, the Quick Setup page automatically displays.
Otherwise, the Home page displays.
Note:
menu on the left.
SecureLinx SLC User Guide
The Restore Factory Defaults password is only for the LCD. You can change
on page 33.)
To open the Quick Setup page at another time, click Quick Setup on the main
4: Quick Setup
27