Diagnostics
General
Remote Syslog
Servers (#1 and #2)
Enable Audit Log
Audit Log Size
Include CLI
Commands
Include In System
Log
3. Enable or disable the following methods of accessing the system:
Note:
Enable SSH Logins
Timeout
Enable Web SSH
SecureLinx SLC User Guide
Messages concerning system status and problems.
Any message not in the categories above.
IP address of the remote server(s) where system logs
are stored.
The system log is always saved to local SLC storage,
but it is not retained through SLC reboots. Saving the
system log to a server that supports remote logging
services (see RFC 3164) allows the administrator to
save the complete system log history.
Select to save a history of all configuration changes in
a circular log. Disabled by default. The audit log is
saved through SLC reboots. See
147.
The log has a default maximum size of 50 Kbytes
(approximately 500 entries). You can set the maximum
size of the log from 1 to 500 Kbytes.
Select to cause the audit log to include the CLI
commands that have been executed. Disabled by
default.
If enabled, the contents of the audit log are added to
the system log (under the General/Info category/level).
Disabled by default.
For more information about secure logins, see
Enables or disables SSH logins to the SLC to allow
users to access the CLI using SSH. Enabled by default.
This setting does not control SSH access to individual
device ports. (See
for information on enabling SSH access to individual
ports.)
Most system administrators enable SSH logins, which
is the preferred method of accessing the system.
If you enable SSH logins, you can cause an idle
connection to disconnect after a specified number of
minutes. Select Yes and enter a value of from 1 to 30
minutes.
Note:
You must reboot the unit before a change will
take effect.
Enables or disables the ability to access the SLC
command Iine interface using Web SSH. Disabled by
default. on page 156.)
Audit Log
on page
A: Security Considerations.
Device Ports – Settings
on page 64
7: Services
54
Need help?
Do you have a question about the SecureLinx SLC48 and is the answer not in the manual?