Command Line Help; Tips - Lantronix SecureLinx SLC48 User Manual

Action
connect
diag
pccard
admin
logout

Command Line Help

For general Help and to display the commands to which you have rights, type:
help
For general command line Help, type:
help command line
For more information about a specific command, type help followed by the command,
for example:
help set network or help admin firmware

Tips

SecureLinx SLC User Guide
Category
deviceport | locallog | sysstatus| syslog | auditlog |
portstatus | sysconfig | portcounters | connections |
slcnetwork | sshkey | history | cli | user | slcnetwork
direct | listen | bidirection | unidirection | terminate
ping | loopback | traceroute | arp | lookup | netstat |
perfstat | sendpacket | nettrace
storage | modem
reboot | shutdown | ftp | config | firmware | version |
banner | keypad | quicksetup | web | events
Terminates CLI session.
Type enough characters to uniquely identify the action, category, or parameter
name. For parameter values, type the entire value. For example, you can
shorten:
set network port 1 state static ipaddr 122.3.10.1 mask
255.255.0.0
to
se net po 1 st static ip 122.3.10.1 ma 255.255.0.0
Use the Tab key to automatically complete action, category, or parameter
names. Type a partial name and press Tab either to complete the name if only
one is possible, or to display the possible names if more than one is possible.
Following a space after the preceding name, Tab displays all possible names.
Should you make a mistake while typing, backspace by pressing the Backspace
key and/or the Delete key, depending on how you accessed the interface. Both
keys work if you use VT100 emulation in your terminal access program when
connecting to the console port. Use the left and right arrow keys to move within
a command.
Use the up and down arrows to scroll through previously entered commands. If
desired, select one and edit it. You can scroll through up to 100 previous
commands entered in the session.
To clear an IP address, type 0.0.0.0, or to clear a non-IP address value, type
CLEAR.
14: Command Reference
169