Hostname
Domain
Enable IP
Forwarding
4. Configure up to three name servers. The first three DNS servers acquired via
DHCP through Eth1 and/or Eth2 display automatically.
DNS Servers
#1
#2 (optional)
#3 (optional)
DHCP-Acquired DNS Servers
#1
#2
#3
GPRS-Acquired DNS Servers
#1
#2
#3
SecureLinx SLC User Guide
The default host name is slc. There is a 64-character limit
(contiguous characters, no spaces).
Note:
The host name becomes the prompt in the
command line interface.
If desired, specify a domain name (for example,
support.lantronix.com). The domain name is used for host
name resolution within the SLC. For example, if abcd is
specified for the SMTP server, and mydomain.com is
specified for the domain, if abcd cannot be resolved, the
SLC attempts to resolve abcd.mydomain.com for the
SMTP server.
IP forwarding enables network traffic received on one
interface (Eth1, Eth2, or an external/PC Card modem
attached to the SLC with an active PPP connection) to be
transferred out another interface (any of the above). The
default behavior (if IP forwarding is disabled) is for network
traffic to be received but not routed to another destination.
Enabling IP forwarding is required if you enable Network
Address Translation (NAT) for any device port modem or
PC Card/ISDN modem. IP forwarding allows a user
accessing the SLC over a modem to access the network
connected to Eth1 or Eth2.
IP address of the primary name server. This entry is
required if you choose to configure DNS (Domain Name
Server) servers.
IP address of the second DNS name server.
IP address of the third DNS name server.
Displays the IP address of the primary name server if
automatically assigned by DHCP
Displays the IP address of the second DNS server if
assigned by DHCP.
Displays the IP address of the third DNS server if assigned
by DHCP.
Displays the IP address of the primary name server if
automatically assigned by General Packet Radio Service
(GPRS).
Displays the IP address of the second DNS server if
assigned by GPRS.
Displays the IP address of the third DNS server if assigned
by GPRS.
6: Basic Parameters
43
Need help?
Do you have a question about the SecureLinx SLC48 and is the answer not in the manual?
Questions and answers