Routing Commands; Services Commands - Lantronix SecureLinx SLC48 User Manual

Routing Commands

set routing
Syntax
set routing [parameters]
Description
Configures static or dynamic routing.
To delete a static route, set the IP address, mask, and gateway parameters to 0.0.0.0.
Parameters
rip <enable|disable>
route <1-64> ipaddr <IP Address> mask <Netmask> gateway <IP Address>
static <enable|disable>
version <1|2|both>
show routing
Syntax
show routing [resolveip <enable|disable>] [email <Email Address>]
Description
Sets the routing table to display IP addresses (disable) or the corresponding host names
(enable). You can optionally email the displayed information.

Services Commands

set services
Syntax
set services <one or more services parameters>
Description
Configures services (system logging, SSH and Telnet access, SSH and Telnet timeout, SNMP
agent, email (SMTP) server, and audit log):
Parameters
auditlog <enable|disable>
auditsize <Size in Kbytes>
Limit is 1-500 Kbytes
authlog <off|error|warning|info|debug>
clicommands <enable|disable>
contact <Admin contact info>
devlog <off|error|warning|info|debug>
diaglog <off|error|warning|info|debug>
genlog <off|error|warning|info|debug>
includesyslog <enable|disable>
SecureLinx SLC User Guide
14: Command Reference
202