Lantronix SecureLinx SLC48 User Manual page 48

2. Enter the following:
Dynamic Routing
Enable RIP
RIP Version
Static Routing
Enable Static
Routing
3. Click Apply.
Note:
Status/Reports page displays. To view the report, select the IP Routes checkbox and
click Generate Report.
SecureLinx SLC User Guide
Select to enable Dynamic Routing Information Protocol
(RIP) to assign routes automatically. Disabled by default.
Select the RIP version. The default is 2.
Select to assign the routes manually. The system
administrator usually provides the routes. Disabled by
default.
To add a static route, enter the IP Address, Subnet
Mask, and Gateway for the route and click the
Add/Edit Route button. The route displays in the Static
Routes table. You can add up to 64 static routes.
To edit a static route, select the radio button to the right
of the route, change the IP Address, Subnet Mask,
and Gateway fields as desired, and click the Add/Edit
Route button.
To delete a static route, select the radio button to the
right of the route and click the Delete Route button.
To display the routing table, click the IP Routes Report link. The
6: Basic Parameters
48