Voip Fields; Table 40 Voip Line Data Fields - Nortel BCM 3.7 Manual

Table 39 DPNSS line fields (Continued)
Attribute Value
Use auxiliary Y or N
ringer
Full autohold Y or N
WARNING: Enable modules
If you disabled any trunk media bay modules prior to performing programming, enable them now to
ensure your system will function properly.

VoIP fields

Table 40 VoIP line data fields

Attribute Value
Line type Public
Private to:
Pool A to O
Description
Turn the auxiliary ringer on or off for all telephones using this line.
When programmed on a line, the auxiliary ringer will ring every time a call is
received.
Note: When programmed only on a telephone, no ring occurs for a transferred call.
An auxiliary ringer can also be programmed in Services to ring for a line placed into
a scheduled Ringing service. Refer to
Enables or disables Full autohold.
When enabled, if a caller selects an idle line but does not dial any digits, that line is
automatically placed on hold if you then select another line.
The default setting should be changed only if Full autohold is required for a specific
application.
Description
Define how the line is used in relation to other lines in the system.
• Public line: can be accessed by more than one telephone.
• Private line: can be assigned only to one telephone and the prime telephone for
that line. Enter the internal number of the telephone.
• Pool A - O/PRI A to PRI F: assigns the line to one of the
15 line pools. If a line is assigned to a line pool, but is not assigned to any
telephone, that line is available only for outgoing calls.
For more information and tips, refer to
Assigning Trunk/line data
"Configuring ringing service" on page 496
"Line pool tips" on page
Programming Operations Guide
265
271.