Lan Settings For Dhcp Relay Agent; Table 170 Relay Agent Interface Parameters - Nortel BCM 3.7 Manual

LAN settings for DHCP Relay Agent

If you configured the DHCP mode as DHCPRelayAgent (refer to
on page 642), then configure the LAN scope attributes as follows. If the mode is DHCPServer
refer to "LAN settings for DHCP Server" on page
1 On the navigation tree, click the Services key and click the DHCP key.
2
Click the Local Scope key and click the LAN1 heading.
The Relay Agent Interface Parameters screen appears.
Note: If your Business Communications Manager system has multiple LAN interfaces,
you can see multiple DHCP scopes under DHCP. They are named LAN1 and LAN2. This
section describes configuring the DHCP scope for LAN1. Follow the same instructions to
configure any of the parameters under the scope for LAN2.
3
Configure the Relay Agent Interface parameters according to the following table.

Table 170 Relay Agent Interface parameters

Attribute Description
Relay DHCP Allows you to enable or disable the relay of DHCP packets on this interface.
packets
The default is disabled.
Hop-count Allows you to specify the maximum number of hops. After this number of hops, DHCP
threshold. requests are discarded.
The values are 0 to 16. The default value is 4.
Seconds-since-boot Allows you to specify the minimum number of seconds since the last boot of Business
threshold Communications Manager, before Business Communications Manager forwards DHCP
requests.
The values are 1 to 3600. The default value is 4.
4
Press the Tab key to save the settings.
LAN settings for DHCP Relay Agent
"Configuring the DHCP Mode"
646.
Programming Operations Guide
663