Explaining The Media Bay Modules Headings; Figure 35 Resources, Media Bay Modules Menus - Nortel BCM 3.7 Manual

136

Explaining the Media Bay Modules headings

system supports double density on all six buses. Refer to
resources," on page
Explaining the Media Bay Modules headings
The Resources, Media Bay Modules heading allows you to view and change settings for each
media bay module installed in Business Communications Manager.
When you choose a region during your system startup, the Business Communications Manager
installs a default set of media bay module settings under Resources, Media Bay Modules.
However, these may not be the settings that you want for the modules you install. Therefore, when
you install a module, you must go to the appropriate Resources, Media Bay Modules, Bus ##
record and verify the settings for the module you installed.
This section includes information about:
• "Media bay module Bus numbers" on page 137
• "Identifying the module" on page 137
• "Module types and capacities" on page 140
• "Ports on Bus" on page 142
The following figure illustrates the headings found under Resources, Media Bay Modules
heading on the navigation tree. The exact items displayed below the Bus XX headings depends on
the type of module configured for that DS30 number.

Figure 35 Resources, Media Bay Modules menus

Resources
LAN
WAN
Media Services Card
Media Bay Modules
Bus 01
Bus 02
Ports on Bus
Port 0201 to Port 0216
Bus 03
Modules on Bus
Module 1
Module 2
Module 3
Ports on Bus
N0008589 3.3
613.
Channels
B1
Addons
B2
Addons
Provision Loops
Loop 301 to Loop 304
Lines on Loop
Chapter 26, "Configuring the MSC
Media Bay Modules (continued)
Bus 04
Modules on Bus
Module 1
Call-by-call service selection
Foreign Exchange (FX)
Inwats (800)
T1 Parameters
Provision lines
Line 211 to Line 233
Module 2
Module 3
Ports on Bus
Port 0201
Channels
B1
Addons
Addon 01
Addon 02
Bus 05
Bus 06
Bus 07
Bus 08
Dial Up
DECT