Assigning The Line; Removing A Line Assignment; Removing The Line - Nortel BCM 3.7 Manual

166 Configuring the DDI Mux module
5 Click the Trunk/line data heading.
6 Click the Trunk type drop list and then click Fixed data channel.
7 Repeat steps 5 to 7 for each line you want to assign to the Data Module.

Assigning the line

1 Click the Resources key and then the Media Bay Modules key.
2 Click the key beside the Bus number assigned to the Data Module.
In this release of Business Communications Manager, the Data Module is always Bus 08.
3 Click the Data module key and click the Interfaces key.
4 Click the key beside the Interface to which you want to add a line. For example, click the key
beside Interface 02.
Note: You can add all of the lines to the single Interface, or you can the lines to
multiple interfaces.
5
Click the Line assignment heading below you Interface to which you are adding lines.
6
Click the Add button.
The Add Fixed line assignment dialog box appears.
7 In the Line box, enter the line number of one of the lines assigned to the Data Module.
Note: You can assign up to 24 lines to the DDI Mux.
You can assign only Fixed lines.
8
Click the Save button.
9
If you are adding all of the lines to a single Interface, repeat steps 6 to 8 for each line you want
to assign to the Data Module.
If you are adding the lines to multiple Interfaces, repeat steps 4 to 8 for each line you want to
assign to the Data Module.

Removing a line assignment

If you decide you want to remove a line assignment from the Data Module and use it as a
telephony line, use the procedure below:

Removing the line

1 Click the Resources key and click the Media Bay Modules key.
2 Click the key beside the Bus number assigned to the Data Module.
3 Click the Data module key and click the Interfaces key.
4 Click the key beside the Interface number from which you want to remove the line assignment.
N0008589 3.3