Adding Remote User Accounts; Table 239 Ipsec Remote User Account Settings - Nortel BCM 3.7 Manual

Adding Remote User Accounts

1 On the navigation tree, click the Services key and click the VPN key.
2 Click the IPSec key and click the Remote User Accounts heading.
3
Click the Remote User Summary tab.
The Remote User Summary screen appears.
4
Click the Add button.
Or, right click the Remote User Accounts heading and click Add.
The Add Remote User Accounts dialog box appears.
5
Configure the Remote User Accounts settings according to the following table.

Table 239 IPSec Remote User Account settings

Attribute Description
User Number Allows you to specify the Remote User identifier.
The User Number uniquely identifies a Remote User. The value for this setting must follow
certain conventions. You must type the prefix 'U' followed by a unique number identifying the
Remote User. For example, 'U2' is a valid name. If you specify an existing Remote User
number, you receive an error message. The User Number identifier does not have any
significance, other than uniquely identifying an entry.
User Name Allows you to specify the user name that the remote computer uses to access the IPSec
tunnel.
Password Allows you to specify the password that the remote computer uses to access the IPSec tunnel.
Note: The password you choose must conform to the password policy used for your Business
Communications Manager system. For more information about the password policy, refer to
"Setting password policy" on page
Confirm Password Allows you to re-enter the password to confirm that the password was entered correctly.
IP Address Pool Allows you to select the Remote IP Address Pool List you want to use for this Remote User
Name Account.
This allows you to assign a Dynamic IP Address (from the IP Address Pool) to the Remote
User when they connect.
Note1: If you select a Remote IP Address Pool List you do not have to specify the Static IP
Address or the Static subnet mask.
Note2: You must add a Remote IP Address Pool List before you can select it from the drop list.
Static IP Address Allows you to specify the IP address that is used by the remote computer, if the remote
computer is using a static IP address.
Note: You do not need to enter a Static IP address if the Account is using a dynamic IP
Address Pool.
Static Subnet Mask Allows you to specify the Subnet Mask that is used by the remote computer, if the remote
computer is using a static IP address.
Note: You do not need to enter a Static Subnet Mask if the remote computer is using dynamic
IP addressing.
IPSec Status Allows you to view the current status of this IPSec Tunnel.
You can also use this field to enable or disable this IPSec tunnel.
You can choose Enabled or Disabled.
The default setting is Disabled.
134.
Programming Operations Guide
IPSec 789