Setting Swca Call Groups; Configuring Swca Call Groups; Figure 136 Swca Call Groups Screen; Table 85 User Preference Choices - Nortel BCM 3.7 Manual

Setting SWCA call groups

Although System-side Call Appearance (SWCA) assignments are meant to be assigned to buttons
with indicators, you can assign SWCA assignments to a telephone without assigning them to
buttons using the fields on this screen.
This is useful if you want to use the full range of SWCA assignments.
Users can park or retrieve calls on any SWCA assignment, even if it is not directly assigned to
their telephone. However, the SWCA support codes (FEATURE *520, FEATURE *537 and
FEATURE *538) only search for SWCA assignments that are assigned to the telephone where the
feature is invoked. These codes are required for users who do not have buttons with indicators.

Configuring SWCA call groups

Use these steps to program SWCA call groups for a telephone.
1
If you are not already in the DN record, click the key beside the telephone DN to which you
want to assign SWCA.
2 Click the key beside Capabilities, then click the SWCA call groups heading.

Figure 136 SWCA call groups screen

3
Use the information in the following table to configure user preferences.

Table 85 User preference choices

Setting
SWCA call group
Values Description
Call 1-16 These groups correspond with the SWCA codes FEATURE *521 to
FEATURE *536. These assignments do not appear on telephone
buttons.
You can assign them to any digital or IP telephone, including the
7000 and 7100 digital phones.
Refer to the SWCA User Card for detailed instructions about using
SWCA assignments.
Setting SWCA call groups
Programming Operations Guide
427