Turn Privacy On Or Off For A Call - Nortel BCM 3.7 Manual

270 Assigning Trunk/line data
Table 41 Combined line settings table (Continued)
Trunk types Attribute
Loop start analog Loss
Packages
DID Signaling
E&M
DID ANI Number
E&M
E&M DNIS
Number
E&M *Gain
Loop Start (GATM Impedance
only)
Loop start analog Redirect to
Loop start digital
Ground start digital
DID
E&M
Target lines
DASS2
WARNING: Enable modules
If you disabled any trunk media bay modules prior to performing programming, enable them
now to ensure your system will function properly.

Turn Privacy on or off for a call

You can configure lines in your system to have automatic privacy. With a line not programmed
with privacy, anyone with the line assigned to their telephone can join your call by pressing the
line button. With a line programmed with privacy, one person at a time can use the line.
Use Feature 83 to turn the privacy feature off and on.
Privacy control cannot be used for internal or conference calls.
When another telephone joins a call, the participants on the call hear a tone, and a message appears
on the telephone display. It is not possible to join a call without everyone hearing this tone.
N0008589 3.3
Value Description
Short CO Select the appropriate loss/gain and impedance settings for
Medium CO each line.
Long CO
For more information refer to
Short PBX
272.
Long PBX
WinkStart Select the signal type for the line. The immediate setting
does not appear for T1 E&M or T1 DID trunks connected to a
Immediate
DTM if the Dial mode is set to tone.
DelayDial
Make sure that this matches the signal type programmed for
the trunk at the other switch.
Y or N Define whether the telephone number of the caller will be
collected for this line.
For T1 E&M and T1 DID trunks connected to a DTM, this
setting only appears if Signaling is set to WinkStart.
The central office must deliver ANI/DNIS in DTMF mode. No
additional equipment is required.
Y or N Defines whether the digits dialed by an external caller on this
line will be collected.For T1 E&M trunks connected to a DTM,
this setting only appears if Signaling is set to WinkStart and
Answer mode is set to Manual.
These digits are required for some third-party software
applications.
Normal Set the level of gain for the channel.
High *E&M trunks only. T1 E&M trunks do not have this field.
600 ohm The GATM can be set to a specific impedance level.
900 ohm
<dial string> Enter a dial string (including routing code) to redirect the line
to an external telephone, such as a call attendant on another
system.
If you want to stop redirection, you need to delete the dial
string and allow the record to update.
"Using loss packages" on page