Configuring Ip Routing Global Settings; Setting The Rip Global Settings; Table 201 Ip Routing Summary Attributes; Table 202 Ip Rip Global Settings - Nortel BCM 3.7 Manual

Configuring IP Routing global settings

This section describes how to configure global settings for the IP Routing.
It also includes information about:
• "Setting the RIP Global Settings" on page 711
• "Setting the OSPF Global Settings" on page 712
To configure global settings for IP Routing:
1
On the navigation tree, click the Services key and click the IP Routing heading.
The IP routing Summary screen appears.
2
Configure the Routing Summary attributes according to the following table.

Table 201 IP Routing Summary attributes

Attribute Description
Description Shows a description of the router.
Version Shows the version of the router.
Status Shows you the status of the router. The possible values are:
Up: the IP router is currently functioning.
Enabled: allows you to enable the router.
Disabled: allows you to disable the router.

Setting the RIP Global Settings

If your network uses RIP, configure the RIP Global Settings as described below. If your network
uses OSPF, refer to
1
Click the RIP Global Settings tab.
The RIP Global Settings screen appears.
2
Configure the RIP Global Settings according to the following table.

Table 202 IP RIP Global Settings

Attribute
Description
RIP Log Level Allows you to enable the recording of events in the Event Viewer. The following options are
available:
Maximum, logs all information in the Event Viewer.
Warnings Also, logs errors and warnings in the Event Viewer.
Errors Only, logs errors in the Event Viewer.
Disabled, disables event logs.
The default value is Errors Only.
Triggered Update Allows you to specify the minimum interval, in seconds, at which a router must send a routing
Interval table update if the metric for a given route changes. If the router detects a change in the routing
information, the router sends an update message at the specified interval.
Possible values are 1 to 50000.
The default value is 5.
"Setting the OSPF Global Settings" on page
Configuring IP Routing global settings
712.
Programming Operations Guide
711