Setting The Ospf Global Settings; Table 203 Ip Ospf Global Settings - Nortel BCM 3.7 Manual

712 Configuring IP Routing global settings
3 Press the TAB key to save your settings.

Setting the OSPF Global Settings

If OSPF is the routing protocol of your choice, configure the OSPF Global Settings as described
below.
1 Click the OSPF Global Settings tab.
The OSPF Global Settings screen appears.
2 Configure the OSPF Global Settings according to the following table.

Table 203 IP OSPF Global Settings

Attribute Description
OSPF Log Level Allows you to enable the recording of events in the Event Viewer. The following options are
available:
Maximum, logs all information in the Event Viewer.
Warnings Also, logs errors and warnings in the Event Viewer.
Errors Only, logs errors in the Event Viewer.
Disabled, disables event logs.
The default value is Errors Only.
Router ID Allows you to specify the IP address that uniquely identifies the Business Communications
Manager router on your network.
Router Area ID Allows you to specify the area where your Business Communications Manager router is located
on your network.
The default value is 0.0.0.0.
Authentication Allows you to enable or disable password authentication.
Type
Values are None, Password.
The default value is None.
For information on how to set the authentication password, see
on a network interface" on page
3
Press the TAB key to save your settings.
N0008589 3.3
716.
"Configuring OSPF parameters