Table of Contents
Advertisement
570
Meridian MCDN call features over PRI SL-1 lines
Programming notes
Business Communications Manager programming
To select Remote Capability for MWI on a per-loop basis for PRI:
Resources, Media Bay Modules, Bus XX, Modules on bus,
Module X:
Remote Capability MWI = Y (if M1 has MWI package, with RCAP
set to MWI)
Turning on the service for IP trunks:
Services, General Settings, IP Trunking:
Remote Capability MWI = Y (if M1 has MWI package, with RCAP
set to MWI)
Telco features, VMsg Ctr Tel Numbers:
•
Voice Message Center 1 set to DES code plus M1 voice mail
DN
Lines (target line), Telco features:
•
choose Voice message Center 1
System DNs, Active set DNs, Line access, Line assignment:
•
assign target line to each set
•
in target line, VMsg set to Y
N0008589 3.3
M1 programming
1. Disable the PBX D-channel
associated with IPT (LD96).
2. Add MWI to the RCAP of the
D-channel (LD 17 RCAP MWI)
3. Ensure the RLS ID is a minimum
of 25 (RLS ID 25).
4. Re-enabled the PBX D-channel.
Note: Package 219 is required on
the Meridian PBX to allow RCAP
MWI.
Note: If IP routing is being used, you
must complete this procedure on all
the D-channels in the private
network.
Advertisement
Table of Contents
